Yosemite Home Decor DF-EFP620-SS Use and Care Manual

Electric FireplaceCARE & USE GUIDE www.YosemiteHomeDecor.com Electric Fireplace CARE & USE GUIDE Yosemite Home Décor 1-800-305-9

10 | P a g e 5. Line up the new motherboard with the existing motherboard, detach the plugs and place plugs into correct location on new mo

11 | P a g e Replacing Motor 1. Unscrew top cover from firebox. 2. Unscrew side screws that will allow for glass to slide off. 3. Locate

12 | P a g e 4. Remove the black trimmings from the inside border of the firebox. 5. Remove screws and then slide out the glowing embers. 6.

13 | P a g e 7. With rod removed loosen the bracket which holds the motor into place. 8. The motor has a wire attached to the motherboard. 9.

14 | P a g e Replacing the Speaker/ USB Port on DF-EFP700 1. Unlatch the cover faceplate from the firebox. 2. Loosen screws that attach the spe

15 | P a g e ELECTRIC FIREPLACE TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

2 | P a g e IMPORTANT INSTRUCTION Read all instructions and warnings carefully before starting installation to reduce the risk of fire, electric sh

3 | P a g e 13. All electrical heaters have hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable

4 | P a g e MAINTENANCE INSTRUCTIONS Yosemite Home Décor’s Electric fireplaces use Incandescent candelabra bulbs, rating voltage 120 volts, 40 Wat

5 | P a g e Replacing Rod Disconnect power supply before beginning any maintenance. Place the Front glass in the safe position. 1. Unscrew top

6 | P a g e 4. Remove the black trimming from the inside of the firebox. 5. Remove screws and then slide out the glowing embers. 6. The rod

7 | P a g e Replacing Blower 1. Remove front covers off the top and bottom of the firebox. (Side view of cover being taken off) (View from

8 | P a g e 4. Unscrew the socket bracket that holds the light bulb in place. 5. Remove the fan wires that are connected to the heater. Repla

9 | P a g e Replacing Printed Circuit Board (motherboard) 1. Remove screws from the top of the firebox and the upper part of the