READ AND SAVE THESE INSTRUCTIONS (this photo for reference only) OWNERS INSTRUCTION MANUAL FOR DUAL MOUNT FAN’S INSTALLATION OPERATION MAINTENA
1. Four wires are connected to the top of the fan. Black: ” Hot” Power/Live for the fan Blue: “ Hot” Power/ Live for the light kit White: “Common”/Ne
1. Place screw through the blade and start the screw into the blade arm repeat this procedure without tightening the screw until all 3 scre
1. Locate two wires in the switch housing (white and blue labeled “for light”). 2. Connect them to the light kit wire connectors (Fig. 12) White to
1. Remove switch housing screws and then remove bottom cap of switch housing shell on fan. 2. Locate two wires in the switch housing (
1. You may purchase a fan with Light Pan instead of cluster light kit mentioned above. For any kind of light kit, you should complete the blade instal
1. Remove switch housing screws and then remove bottom cap of switch housing shell on fan. 2. Locate two wires in the switch housing (
1. Restore electrical power by turning on the electricity at the main fuse box. 2. Turn on the wall switch. 3. Your fan has two controls on the s
1. The fan natural movements may cause some connections to work loose. A clicking or rattling noise is a certain sign of loosening screws. Ch
MAINTENANCE FAN DOES NOT START 1. Check all fuses or circuit breakers. Replace if MISSING. 2. Turn off electrical power and check all wire connectio
5. If the above does not eliminate the wobble, clip a balancing kit on any one of blade about the middle of blade edge. Le
Safety Tips -----------------------------------------------------------------------------------2Unpacking Your Fan -------------------------------
TABLE OF CONTENTS 1. To avoid possible electric shock, turn off the electricity at the main fuse box or circuit panel before you begin the fan instal
SAFETY TIPS 1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary the
1. If there is an existing outlet box, ensure it is clearly marked” Suitable For Fan Support”. If not, it must be replaced with an approv
1. To avoid possible electrical shock, be sure electricity is turned off at the main power panel before wiring. All wiring must be in accordance
INSTALLING THE FAN SELECT TYPE OF INSTALLATION Page 6 HUGGER(ORIGINAL DESIGN)HANG DOWN1. Put 2 screws in the hanger bracket. Leaving them partially o
Page 7 Fig.6.3Fig.6.5Fig.6.1Fig.6.2Fig.6.41 Slide the canopy on the downrod(Fig.7) Thread the power leads from the fan through the canopy
Page 8 3. Tighten motor set screw. Check the strength of this connection (pre-tightened at factory) by holding the motor housing in position
Comments to this Manuals